Blueendless Offline Clone Dual Protocol M.2 SSD Case SSD Docking Station Type C 10Gbps for PCIe NVMe or SATA 2 Bay SSD Enclosure

Blueendless offline clone Dual Protocol m.2 ssd case Ssd Docking Station

 

please note:

Please check your SSD hard drive protocol type before ordering

 

DB280SC：for 2 bay M.2 sata SSD,speed:5Gbps

SD06C ：or 1pcs M.2 sata SSD and 1pcs M.2 NVME SSD

             speed: sata ssd 6Gbps       NVME ssd 10Gbps

DB280NC:  for 2 bay M.2 NVME SSD or 2 bay M.2 SATA SSD

             speed: sata ssd 6Gbps       NVME ssd 20Gbps

 

plastic material with RGB Light,5V/3A power adapter.

this is only a ssd docking,it doesn’tcontain the hard disk.

 

Offline Copy Operation 3 steps:

1、 After connecting the hard drive and the power adapter, press and hold the copy buttonuntil all lights start flashing. Release it and press again, then the copying process will begin.

2、 When the copying starts, all indicator lights will flash, indicating that cloning or read/write operations have begun.

3、 During cloning, the progress will be indicated by the lights in increments of 25%showing 25%, 50%, 75%, and finally 100%. After reaching 100%, the four percentageindicator lights will remain steadily lit, indicating that the cloning process is complete.

 

please pay attention to the following matters when using the offline clone function.

1.back disk(B) must be larger capacity(eliminate space loss) than front disk(A),
Plug in identify Source Disk(front port) and Target Disk(back port)

Connect power supply and switch on power. (make sure that the USB cable is disconnected)
2.To avoid your disk file damaged,please don’t stop the device when it’s under clone function.
3.When copy disk,please make sure disk B is empty,or the former file in disk B will be loss.(if disk B has file before,and just want to copy from disk A,please don’t use offline clone function,just copy and paste on computer)
4.When offline copy the disk,please don’t connect the computer,if connect the computer,disk will be under reading,can not support copy(device heating is normally,as big hard disk operate will be hot)

5.if the clone is interrupted ,you need to restart the device and clone again.